Home
blog
IceCap Nano Flow Pump User Instructions

IceCap Nano Flow Pump User Instructions

Loading... 43 view(s)

Thank You for Your IceCap Purchase

We appreciate your confidence in our IceCap product. If for any reason you are missing, have an issue with the product, or just have a simple question, please get in touch with our support staff at support.coralvue.com.

These instructions are dedicated to the IceCap Nano Flow Pump models, including IC-WM1500M, IC-WM3000M. Please keep the magnet base away from children.

IceCap Flow Pump Includes:

- Flow Pump with Mounting Magnet
- Inline Flow Controller
- Power Supply (PSU)

Pump Installation

Please remember the following pump installation instructions:

1. Locate and clean the surface area where you intend to install the pump.

2. Position the Inner Magnet Mount and the Dry Side Mount in your preferred location. Be cautious not to let the two magnets snap together when mounting.

3. Attach the pump to the inner magnet, ensuring that the power cable is facing upwards. Be sure there is a drip loop between the pump and the inline controller.

4. Plug the inline controller to the power supply and then then plug the psu into a working GFCI power outlet.

WARNING: The creation of waves within the aquarium can place excessive stress on the aquarium and its seams. Not all aquariums can withstand stress produced by waves. We are not responsible for any damage to the surrounding environment or indirect damage caused by the production of waves within the aquarium.

Controller Installation

Please ensure that you mount the controller in a dry location within reach of the flow pump using screws (not included). Make sure to leave a drip loop between the controller and the pump. Next, plug the power supply into the power port of the controller and then plug the other end into your home receptacle.

IceCap Flow Pump Controller Functions

There are 11(eleven) wave mode steps illustrated in the table below. You can choose the ideal wave action to match your aquarium needs. Press the POWER button once to turn on, press again to trigger a 10minute feed timer and if pressed three times it will power off the pump which is indicated on the controller with an off LED.

<UP> BUTTON: Adjust UP Wave Mode
<DOWN> BUTTON: Adjust DOWN Wave Mode
<POWER> BUTTON: Trigger (1) ON, (2) 10min feed timer, (3) OFF

UP BUTTON (Steps)	Working Time (sec)	Stop Time (sec)
Step 1	0.5	0.5
Step 2	1.0	0.5
Step 3	1.2	0.6
Step 4	2.0	1.0
Step 5	2.5	1.0
Step 6	3.0	1.5
Step 7	4.0	2.0
Step 8	4.5	2.0
Step 9	5.0	2.0
Step 10	5.0	2.5
Step 11	All the time	0.0
DOWN BUTTON (Steps)

Maintenance

We recommend cleaning the pump every month or as necessary, using a high-quality pump cleaner or citric acid.

Here are the instructions in a clearer format:

1. Carefully remove the pump from the inner magnet base.
2. To remove the flow cage, rotate it slightly counter-clockwise and away from the pump body.
3. To remove the impeller, rotate the impeller base counterclockwise and pull away from the pump body to expose the impeller magnet and rear shaft assembly.

Posted in: IceCap

Did you like this post?