Home
blog
IceCap DC Media Reactor Instructions

IceCap DC Media Reactor Instructions

Loading... 147 view(s)

Thank You for Your IceCap Purchase

We appreciate your confidence in our IceCap product. If you are missing any information, have an issue with the product, or have a question, please don't hesitate to contact our support staff at support.coralvue.com.

The IceCap Media Reactors can be used with many different media and for both saltwater and freshwater aquariums. Our media reactors are nearly plug-and-play, with only a few steps to take the reactor from the box to your aquarium.

When installing and using this electrical equipment, basic safety precautions should always be followed.

Always unplug the unit from an electrical outlet when not in use or before servicing or cleaning. For indoor use only.

Pre-Installation Inspection

All IceCap media reactor models come fully packaged with all necessary components needed to operate the unit. You only need to supply the media you want to use. When unpacking your new IceCap media reactor, conduct a complete inventory to ensure all parts are included and undamaged. Handle and inspect the unit carefully before installing and connecting it to power. Refer to your specific model below.

Included Parts:

(1) Body

(2) Top

(3) Upper Canister

(4) Lower Canister

(5) Mounting O-Ring

(6) Sponges and Filter Floss

(7) Hang-On Mounting Bracket

(8) Flow Diverter

(9) Power Supply

(10) Pump Controller

(11) 12V DC Feed Pump

Initial Assembly Instructions

Step 1 - Install Feed Pump
Install the feed pump by inserting the pump's output into the bottom of the external vessel housing. Connect the inline controller between the feed pump and the power supply. Place the mounting bracket around the reactor, and place the o-ring above it to secure it in place when mounted. Run the power cord up the reactor and push the line into the slit on the side of the mounting bracket.

Step 2 - Install Media

Carefully remove the empty filter cartridge by pulling it away from the outer body. Rotate the bottom chamber clockwise to separate it. Make sure to use the sponge installed at the bottom of the chamber before filling. Fill the bottom chamber with your preferred media. Place the second included sponge on top of the media and twist lock the bottom chamber onto the top by turning counterclockwise. Be sure to rinse the media thoroughly before use. The top chamber can be filled with filter floss to catch any media that might escape the first chamber, or it can be filled with a different media from the bottom chamber.

Step 3 - Place in Sump

Find a suitable location to install the reactor, which can be hung inside a sump or an all-in-one aquarium filter compartment. Carefully place the reactor in a dedicated section of your sump or filter compartment in an all-in-one aquarium. The controller and power supply are not waterproof and should never be placed above water. Be sure proper drip loops are in place to prevent water from reaching the controller or power supply. To do this, ensure a portion of the cord hangs below the controller and receptacle.

Step 4 - Power On

Connect the pump's power wire to the inline controller and the other end to the power supply. To power your new reactor, plug the power adapter into an electrical outlet and press the power button on the controller. To start, make sure you turn the power level down to its lowest setting and adjust the flow only after observing the media and its flow requirements. Water level inside the reactor can be managed with the flow diverter located at the bottom of the reactor.

Maintenance

Over time, the reactor's efficiency will decrease because the filter pads will accumulate debris and restrict flow through the media. This will require cleaning and regular replacement of the exhausted media. Every 4-6 months, disconnect the pump from power and clean it by removing the impeller cover and impeller. Never use soap or detergents for cleaning.

Posted in: IceCap

Did you like this post?

IceCap DC Media Reactor Instructions